Installation Instruction for Edelbrock QW ikdata Shaft Speed Sensor Kit

In the installation instruction you can find explanation regarding system, shaft speed sensor, and data aquisition. The installation instruction presents discussion regarding speed, speed sensor kit, and data.

installation instruction for edelbrock qw ikdata shaft speed sensor kit page1 7944795 Installation Instruction for Edelbrock QW ikdata Shaft Speed Sensor Kit

There are lots of discussion regarding aquisition, data aquisition system, and sensor are explained in the installation instruction. Here are chosen from this installation instruction:

The beveled edge of the Use a washer .060”-.080” thick to prevent interference with the pinion support radius Set gap at .060”-.100” for Qwikdata use OR Set gap per data aquisition system per manufacturer’s instructions Tighten so that the gaps are even Beveled edge should face Pinion U-Joint Grip Diameter FIGURE 1 Be sure the magnets are seated against the outside shoulder of the ring Fill cavities with epoxy or silicone to secure magnets Note: Some multi-magnet sensors are pole-sensitive and must be installed in correct +/- sequence.

Giving more content, the installation instruction gives you discussion such as speed sensor, shaft speed, and aquisition system.

Download Installation Instruction for Edelbrock QW ikdata Shaft Speed Sensor Kit pdf
File size: 0.015 MB, number of pages: 3, download server: www.edelbrock.com
Related Downloads
This entry was posted in Speed Sensor and tagged , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *