In the technical information the reader can learn things regarding calibration, detection, pump voltage, voltage supply, output amplification, voltage level, interface, pump reversal voltages, detection current, amplified sense, peak detection, average filter, sensor output, step voltage, and zirconium dioxide. There are lots of things around voltage reference, input, threshold, sensing cell, signal conditioning, constant current source, signal processing, output, resolution, noise, adaptive filtering, constant, current source, control, and reference are described inside the technical information.
This technical information contains info around interface electronics, heater, circuit voltage, current, rolling average filter, stage amplification, sensor sense connection, level, buffer size, sample frequency, source, time resolution, amplified signal, control circuit, and amplification. The following are taken from the technical information:
The amplified sense signal should be compared to voltage references which are the specified pump
reversal voltages scaled by the same gain factor as the output amplifier. Each time either the upper or lower reference is met the constant current source should be reversed. This part of the circuit should always start up in the condition that applies the constant current
source between PUMP and COMMON as this begins the evacuation necessary to start the pumping cycle i.e. PUMP should be positive with respect to COMMON
In addition, this technical information presents more about amplified sense signal, value, voltage, time dependant, sensor, signal, constant current, supply, equation, sensor control, sampled sense voltage, timer, oxygen sensors, voltage regulation, and frequency.